Cisco Certified Network Associate (CCNA) Exam 3

Cisco Certified Network Associate (CCNA) Past Questions and Answers

Practice the Cisco Certified Network Associate (CCNA) Exam 3 Past Questions with Answers. Our experts have answered the questions and you will get the correct answers to the Cisco Certified Network Associate (CCNA) questions. Prepare yourself for the exam ahead and test your knowledge and readiness.

0%

Cisco Certified Network Associate (CCNA) Exam 3

CCNA

Cisco Certified Network Associate (CCNA) Exam 3

Questions will be picked at random from the question bank.

You can use the NEXT button to move to the next question, use the PREV button to move to the previous question, the CLEAR button to clear any answer of your choice and you have the FINISH button to end the exam if you choose to.

Any question not answered before the end of the exam time, will be marked as wrong and the exam will end by itself. So try to attempt all questions on time.

Goodluck!

1 / 40

To which class 255.21.24.10 IP belongs to?

2 / 40

Refer to the graphic.

Cisco 200 120 7 2

Host A is communicating with the server. What will be the source MAC address of the frames received by Host A from the server?

3 / 40

In a network of two Cisco switches, one is having priority of 32665 and second having 0, which one will be the root bridge?

4 / 40

In which protocol you can make policies to route traffic? (Choose TWO)

5 / 40

Where does routing occur within the DoD TCP/IP reference model?

6 / 40

Refer to the exhibit.

Cisco 200 120 6 2

Host A pings interface S0/0 on router 3. What is the TTL value for that ping?

7 / 40

Which command is used to see routes in routing table?

8 / 40

Which of the following are valid types of IPv6 address? Choose all that apply.

9 / 40

Host 1 is trying to communicate with Host 2. The e0 interface on Router C is down.

Cisco 200 120 8 2

Which of the following are true? (Choose two.)

10 / 40

Refer to the exhibit:

Cisco 200 120 15 2

What will Router1 do when it receives the data frame shown? (Choose three.)

11 / 40

Which of the following describes the roles of devices in a WAN? (Choose three.)

12 / 40

What should be done before configuring etherchannel?

13 / 40

Which command is used to erase everything on Cisco’s router 2600?

14 / 40

Which three statements accurately describe Layer 2 Ethernet switches? (Choose three.)

15 / 40

Refer to exhibit:

Cisco 200 120 10 2

Which destination addresses will be used by Host A to send data to Host C? (Choose two.)

16 / 40

Cisco 200 120 13 2

 

17 / 40

For what two purposes does the Ethernet protocol use physical addresses? (Choose two.)

18 / 40

Refer to the exhibit.

Cisco 200 120 20 2

A frame on VLAN 1 on switch S1 is sent to switch S2 where the frame is received on VLAN
2. What causes this behavior?

19 / 40

In a Cisco switch, if a revision number is 10 and you deleted 3 VLAN one by one, what will be the final revision number?

20 / 40

A router has two Fast Ethernet interfaces and needs to connect to four VLANs in the local network. How can you accomplish this task, using the fewest physical interfaces and without decreasing network performance?

21 / 40

Refer to the exhibit.

Cisco 200 120 21 2

All switch ports are assigned to the correct VLANs, but none of the hosts connected to
SwitchA can communicate with hosts in the same VLAN connected to SwitchB. Based on the output shown, what is the most likely problem?

22 / 40

Refer to the exhibit.

Cisco 200 120 3 2

Which three statements correctly describe Network Device A? (Choose three.)

23 / 40

A receiving host computes the checksum on a frame and determines that the frame is damaged. The frame is then discarded. At which OSI layer did this happen?

24 / 40

What are the advantages of route summarization? Choose two.

25 / 40

Which three of these statements regarding 802.1Q trunking are correct? (Choose three.)

26 / 40

Refer to the exhibit.

Cisco 200 120 14 2

27 / 40

A network administrator is verifying the configuration of a newly installed host by establishing an FTP connection to a remote server. What is the highest layer of the protocol stack that the network administrator is using for this operation?

28 / 40

Why is VLSM important to modern IP networks?

29 / 40

Refer to the exhibit.

Cisco 200 120 18 2

After HostA pings HostB, which entry will be in the ARP cache of HostA to support this transmission?

Cisco 200 120 18 3

30 / 40

Which of the following are valid transition strategies when moving from IPv4 to IPv6? Choose all that apply.

31 / 40

Which layer in the OSI reference model is responsible for determining the availability of the receiving program and checking to see if enough resources exist for that communication?

32 / 40

Refer to the exhibit.

Cisco 200 120 12 2

What two results would occur if the hub were to be replaced with a switch that is configured with one Ethernet VLAN? (Choose two.)

33 / 40

A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?

34 / 40

Cisco 200 120 16 3

35 / 40

Which of the following statements describe the network shown in the graphic? (Choose two.)

Cisco 200 120 16 2

36 / 40

Which of the following correctly describe steps in the OSI data encapsulation process?
(Choose two.)

37 / 40

Cisco 200 120 19 2

38 / 40

Which of the following is an addressing type that is assigned to network interfaces for communications on the physical network segment?

39 / 40

What is the difference between a CSU/DSU and a modem?

40 / 40

In an Ethernet network, under what two scenarios can devices transmit? (Choose two.)

Your score is

0%

Leave a Comment

Your email address will not be published. Required fields are marked *

error: Content is protected !!
Scroll to Top